Jan 7, 2018 - Hi Guys, New to the forum, I hope someone can help. We have recently bought an apartment which has a relatively old machine, a BlueSky. Aug 06, 2014  download instrucciones lavadora bluesky blf 1011 sp. File name: manual_id280638.pdf Downloads today: 187 Total downloads: 5701 File rating: 8.45 of 10 File size: ~1 MB >>> DOWNLOAD. Download instrucciones lavadora bluesky blf 1011 sp File name: manual_id280638.pdf Downloads today: 187 Total downloads: 5701 File.

• 15935 Answers SOURCE: A lot of concerns have been raised about door bellows molding, mildewing, and/or ripping and needing replaced. A replacement bellow isn't cheap (prices vary, but are around $75-80), so hopefully these helpful steps will eliminate the need to call a repair service and pay the additional labor charges. This is a repair of MODERATE difficulty. Just follow these steps: 1.

Unplug the washer. Remove the washer top panel by removing the three torx-type screws (or 7mm) where it attaches in the rear of the washer. The panel should slide back, and then lift off. Remove the operator console by removing the dispenser and the scew(s) behind it. Take a putty knife and insert it under the console seam right above the door. If you push in slightly while pulling outwards the panel pops off. Use care not to pull or damage any of the wiring.

• C: Documents and Settings to the E: drive • C: ProgramData and C: Users to the D: drive What version of Windows are you using? Hi, Further to what John EB indicated, did you also modify the Program Settings of MMM to point to the locations of your files? Magix music maker soundpool collection.

You can leave the wires attached and simply lay the console across the top of the washer out of the way. Locate the wire hoop retainer around the rubber door boot. It is located behind the rubber seam where it attaches to the door frame. Follow this hoop around to the bottom of the door opening and locate the wire tension spring. Gently pry this spring apart and pull the wire hoop from the groove. Pull the rubber boot from the frame and push it inside towards the wash tub.

You will also have to remove the door boot from the fill tube on the left hand side of the door opening. There is a small wire clamp holding it in place. Remove the three screws that hold the door latch assembly in place. This is on the right hand side of the door opening. You can leave the latch in place as long as you remove the screws and push it inside slightly to remove it from the front casing of the washer. Remove the door by removing the screws holding the hinges in place.

Use care to support the door hinges when loosening. They can bend. Set the door aside in a location where it will not get stepped on or broken. Remove the lower kick panel under the door. There are 3 screws under the bottom edge holding it in place. Spid info s nog nagolovu. Sometimes the panel can stick. A slight tap on either side will knock it free.

Remove the front washer casing by removing the four remaining screws that are holding it in place. There should be two at the top and two at the bottom. Set the front casing aside.

Remove the old door boot by locating the large clamp that attaches it to the wash tub. Loosen the 7mm nut and the boot will detach from the tub.